Get wired!  

pinout (распиновка)

Ethernet 10/100Base-T Crossover Cable

This page not supported any more. Please visit this page

This cable can be used to cascade hubs, or for connecting two Ethernet stations back-to-back without a hub. It works with both 10Base-T and 100Base-TX


8 pin RJ45 MALE connector  to the network interface card 1
Name NIC1 NIC2 Name
TX+ 1 3 RX+
TX- 2 6 RX-
RX+ 3 1 TX+
RX- 6 2 TX-

8 pin RJ45 MALE connector  to the network interface card 2

Note 1: It's important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair. (Just as the table above shows). Note 2: You could also connect 4-4, 5-5, 7-7, 8-8.

Реклама: